4-22
NOTE: Pentium II Processor Install
If the retention module is not already installed on the system board:
•
Place the EMC clip over the correct post on the screw bracket.
•
Press the screw bracket onto the bottom of the system board.
Note: Be sure the EMC Clips are aligned with the holes with ground pad
on the system board.
•
Turn the system board over.
•
Place the retention mechanism over the socket on the system board make
sure the groove matches the one on the processor socket.
Figure 4- 23 Installing the Pentium II Retention Mechanism
To install processor to retention module:
•
With the processor module golden fingers pointing downward, align the
processor to the posts of the retention mechanism then lower it down.
•
The golden fingers of the Pentium II module is slotted such that it only fits
in one direction. Make sure that module groove matches the one on the
processor socket.
To Next Page
Loading...
