Repair Information 4-33
NOTE: System Board Install
•
Before you re-install the new system board, the CPU retention module and
the I/O Port Bracket should be assembled on the system board if they are
not already installed. (refer to the illustration in Chapter 7, Assembly 2 )
•
Be sure to reinstall the processor, DIMMs, onto the new system board if
applicable.
•
Before reinstallation, position the housing on its side. When reinstalling a
new system board, push the board to the rear and align it with the front
locating pin. Visually verify that the board is aligned properly, then press
the board down
•
After installing the system board, secure with original screws.
•
Run the Setup Utility after correctly changing the system board.
•
Upgrade the BIOS version on the new system board. See "Flash (BIOS)
Update Procedure" on page 1-17.
•
Run the Setup Utility after correctly changing the system board. See "BIOS
Setup Utility" on page 1-18.
•
Change the Machine Type and Serial Number in the BIOS for the new
system. See "BIOS-contained Model Number and Serial Number" on page
1-16.
To Next Page
Loading...
