IBM Aptiva - Page 280

I-4
PIO Mode, 1-21
Plug and Play, 1-32
Reset Resource Assignments, 1-
32
POST, 1-2
Fast POST Mode, 1-26
Power consumption, 1-34
Power Management, 1-4, 1-25
IDE Hard Disk Standby Timer, 1-
25
Modem Wake-Up on Ring, 1-25
Power Switch< 4 sec., 1-25
Stop CPU Clock, 1-25
System Sleep Timer, 1-25
Power Supply, 1-5
Check Procedure, 2-39
Connector Specifications, 5-18
Error Symptoms, 2-25
Power Switch
Power Switch< 4 sec., 1-25
Processor
Machine Type 2137, 1-2
Machine Type 2138, 1-2
Error Symptoms, 2-17
R
Real-Time Clock
Error Symptoms, 2-21
Removals and Replacements, 4-2
System Backup Battery(2138
only), 4-27
System Board(2137 only), 4-30
System Board(2138 only), 4-32
Bay 4, 5 (3.5-In. Diskette/Hard
Disk Drives), 4-10
Bay Panels, 4-8
Bays 1, 2, 3 (5.25-In.
Internal/External Bays), 4-9
Cover, 4-6
handling ESD-sensitive parts, 4-34
Identifying the Parts of the System
Unit, 4-4
Pentium II Processor Heat Sink
and Fan(2138 only), 4-23
Pentium II Processor Module(2138
only), 4-21
Power Supply(2137 only), 4-13
Power Supply(2138 only), 4-15
Processor(2137 only), 4-19
Removal Sequence, 4-3
System Backup Battery(2137
only), 4-26
Repair Information, 4-1
S
Safety Information, VI
Safety Inspection Guide, 6-1
Safety Notices, VII
Serial Number, 1-15
Serial Port, 1-22
Addresses, 1-12
Error Symptoms, 2-23
I/O Addresses, 1-10
Interrupt, 1-11
Port Signals, 5-28
Software Recovery Procedure, 7-35
Specifications
Dimension, 1-33
Environment, 1-33
Weight, 1-33
System Board