Check Procedures 2-5
−
Ensure that the monitor brightness and contrast controls are not
turned down.
−
Power on the system unit.
NOTE: Some monitors have a detachable system I/O signal cable between
the monitor and the system unit. In this case, check this signal cable
before replacing the unit. See "Monitor Port Signals" on page 5-28 for
pin identification.
−
Ensure correct monitor refresh rate. See "Refresh Rates and
Monitor Frequencies” on page 1-14.
−
Note any symptoms, messages, error codes, or beeps.
−
Make sure that there are no diskette or CD in the drives.
002 - DOES SYSTEM COMPLETE POST WITH ONE SHORT BEEP AND
DOES AN IBM LOGO SCREEN APPEAR? (YES, READ AHEAD.
NO, GO TO STEP 004.)
−
Insert diagnostics diskette in the diskette drive.
003 - DOES SYSTEM LOAD THE DIAGNOSTICS PROGRAM FROM THE
DISKETTE DRIVE? (YES, READ AHEAD. NO, GO TO STEP 004.)
−
Follow the instructions on the screen and select Utility from the
diagnostics program menu.
−
Select Tech Support Form from the menu, press F5 to execute,
then generate a system configuration report.
−
Compare the system configuration list with the actual devices
installed in system.
NOTE: If necessary, remove the machine cover and visually compare the
devices installed in system to those shown in the system
configuration report.
−
Go to step 006.
004 - DO ANY MESSAGES, ERROR CODES, OR SYMPTOMS APPEAR?
(YES, READ AHEAD. NO, GO TO STEP 005)
−
Go to “Index of Symptoms, Messages, Error Codes, or Beeps” on
page 2-8.
−
End.
005 -
To Next Page
Loading...
