Responding to error codes 125
162 Configuration Error
Configuration Change Has
Occurred
If you are using Rapid Resume, and if you have not installed or removed
hardware, see the HelpWare book for information on obtaining service. Any
work that you did not save before the computer was turned off cannot be
retrieved.
If you are using Rapid Resume
, and if you have installed or removed hardware,
follow these steps:
1. Press the system on/off button to turn off the computer.
2. Return the computer to its previous hardware configuration.
3. Turn on the computer.
4. If the error does not reoccur, save any work you want to keep.
5. Use the Setup Utility to verify that the On/Off Button Mode option is set to
Power Off. For information about this Setup Utility option, see “Rapid
Resume advanced options” on page 43.
6. After you have saved your Setup Utility changes, wait until the Windows 95
desktop is displayed. Then use the system on/off button to turn off the
computer again.
7. Try updating your computer’s hardware again. If you are working with the
hardware in your tower, make sure you follow the instructions in
“Chapter 7: Working with adapter cards and drives” on page 77. If you are
working with the components on your system board, make sure you follow
the instructions in “Chapter 6: Working with system board components”
on page 63.
8. If the error occurs again, see the HelpWare book for information on
obtaining service.
(Steps continued on the next page.)
Table 7: Error codes, descriptions, and corrective actions
Error Code Description Here’s what to do:
Notes:
1. An X shown as part of the error code in this table represents any number between 0 and 9.
2. If any of these problems continue after taking the actions listed, see your online Aptiva Helper for information on running
diagnostics. If you need service, see the HelpWare book.
To Next Page
Loading...
Need help?
General
