IBM Aptiva

160 Appendix C: Modem information
Xn (cont) Sets the type of return code sent:
n=2 Extended return codes are enabled. Basic return codes, the connect message, and the modem’s data rate are
displayed. Operation of the modem’s error correction and data compression are also indicated.
Dial tone detection is enabled. The modem dials only when a dial tone is detected, and disconnects if the dial tone is
not detected within 10 seconds.
Busy tone detection is disabled. The modem ignores any busy tones it receives.
n=3 Extended return codes are enabled. Basic return codes, the connect message, and the modem’s data rate are
displayed. Operation of the modem’s error correction and data compression are also indicated.
Dial tone detection is disabled. The modem dials regardless of whether a dial tone is detected.
Busy tone detection is enabled. The modem monitors for busy tones.
n=4 Extended return codes are enabled. Basic return codes, the connect message, and the modem’s data rate are
displayed. Operation of the modem’s error correction and data compression are also indicated.
Dial tone detection is enabled. The modem dials only when a dial tone is detected, and disconnects if the dial tone is
not detected within 10 seconds.
Busy tone detection is enabled as the default. The modem monitors for busy tones.
n=5 Extended return codes are enabled. Basic return codes, the connect message, and the modem’s data rate are
displayed. Operation of the modem’s error correction and data compression are also indicated.
Dial tone detection is enabled. The modem dials only when a dial tone is detected, and disconnects if the dial tone is
not detected within 10 seconds.
Busy tone detection is enabled. The modem monitors for busy tones.
n=6 Extended return codes are enabled. Basic return codes, the connect message, and the modem’s data rate are
displayed. Operation of the modem’s error correction and data compression are also indicated.
Dial tone detection is enabled. The modem dials only when a dial tone is detected, and disconnects if the dial tone is
not detected within 10 seconds.
Busy tone detection is enabled. The modem monitors for busy tones.
n=7 Extended return codes are disabled. Only basic return codes, such as OK, CONNECT, RING, NO CARRIER, and
ERROR, are displayed.
Dial tone detection is enabled. The modem dials only when a dial tone is detected, and disconnects if the dial tone is
not detected within 10 seconds.
Busy tone detection is enabled. The modem monitors for busy tones.
Y0 Disables long-space disconnect.
Table 14: Common modem commands
Code/Command Function