108
Chapter 3 Main Menu
NOTES:
Italicized items are available only when Admin User is set to Enable (in the PRINTER CONTROL menu).
1
Available only when Admin User is set to Enable (in the PRINTER CONTROL menu).
2
The presence of this menu depends on the LP+ Emulation selection (under PRINTER CONTROL).
3
These menus do not display when CT, TN5250, or TN3270 emulation is selected.
4
All three Form Length submenus work in conjunction. When you change the default in one submenu, the
default value in the other two submenus change automatically.
5
All three Form Width submenus work in conjunction. When you change the default in one submenu, the
default value in the other two submenus change automatically.
PROPRINTER
SETUP
1, 2, 3
(page 197)
Select CPI
Select LPI
Typeface
Character Group
Character Set
Horizontal DPI
Vertical DPI
Prop. Spacing
Italic Print
Slashed Zero
Left Margin
3
Right Margin
3
Top Margin
Bottom Margin
Print Char. Set
Define CR code
Auto LF
Define LF code
20 CPI Condensed
Bold
FF valid at TOF
Alt. Char Set
Text Position
Host Command
Reset Cmd CFG Ld
Form Length (inches)
3, 4
Form Length (mm)
3, 4
Form Length (lines)
3
Form Width (inches)
3, 5
Form Width (mm)
3, 5
Form Width (char.)
3
Select CPI
Select LPI
Typeface
Character Group
Character Set
Epson Set
Horizontal DPI
Vertical DPI
Prop. Spacing
Italic Print
Slashed Zero
Left Margin
3
Right Margin
3
Top Margin
Bottom Margin
Print Char. Set
Define CR code
Auto LF
Define LF code
Printer Select
20 CPI Condensed
Bold
Alt. Set 80-9F
Text Position
Host Command
Reset Cmd CFG Ld
Form Length (inches)
3, 4
Form Length (mm)
3, 4
Form Length (lines)
3
Form Width (inches)
3, 5
Form Width (mm)
3, 5
Form Width (char.)
3
EPSON FX
SETUP
1, 2, 3
(page 199)
DIAGNOSTICS
(page 248)
Printer Tests
Test Count
Software Build
Feature File
Hex Dump Mode
Print Error Log
Clear Error Log
FLASH Installed
DRAM Installed
Ptr On Time
Ptr Media Dist
Head Print Dist
Head On Time
Reset Head Data
Head Type
Head Voltage
To Next Page
Loading...
Need help?
General
