204
Chapter 3 Emulation Submenus
Auto Skip at End
(From page 168, page 179.) Specifies whether to perform an automatic form
feed at the end of a print buffer. If form feed is the last character in the print
order, the form feed function is supplied by the Auto Skip At End option.
• Off. Sets the printer to print at print position 1 of the next line.
• On. Sets the printer to print at print position 1 of the first line of the next
form.
The factory default is Off.
Auto Uppercase
(From page 184.) This parameter enables the printer to print text in all
uppercase when using the ALPHA command.
• Disable. The printer will print text in upper and lowercase.
• Enable. The printer will print text in uppercase only.
The factory default is Disable.
Autoeject (VGL)
(From page 187.) Determines paper handling upon exiting the VGL Repeated
Form and Dynamic Form commands.
• Disable. Holds the print position at the bottom of the form.
• Enable. Issues a form feed after the last form is printed so all pages will
be physically printed.
The factory default is Disable.
Autowrap
(From page 184.) This parameter determines if text will wrap to the next line
when the line of text exceeds the right margin.
• Disable. Truncates the text beyond the right margin until a CR or CR + LF
is received.
• Enable. Automatically inserts a CR + LF after a full print line.
The factory default is Disable.
To Next Page
Loading...
Need help?
General
