Overview
241
SPC Space Supp
(From page 173.) This option is only available in Coax SPC emulation and is
used in LU3/DSC/DSE mode only.
• Disable (the default). Treats nulls and spaces normally.
• Enable. If the entire line consists of spaces and nulls, the line will be
discarded.
SPC Type (SPC Coax Setup)
(From page 173.)
• PTX NI (Printronix Non-impact) (the default). This option causes the
printer to not line wrap at 132 characters.
• Avatar Comp. This option causes the printer to line wrap at 132
characters despite the current print density allowing more characters per
line.
SPC Type (SPC Twinax Setup)
(From page 174.) Allows you to select a convertor which mimics a specific
type of external protocol convertor:
• MODE PTX NI (the default) for IBM non-impact
• MODE 219 for Model 219 protocol convertor
• MODE P5000 for Printronix protocol convertor
• MODE IBM for the IBM protocol convertor
Standard Sets
(From page 184, page 189.) This item allows you to select various character
sets available from the “Character Group” item.
The options are Standard, Arabic, Cyrillic, European, Greek, Hebrew, and
Turkish Sets.
The factory default is Standard Sets.
Text Length
(From page 187.) Text Length is the printable length on the page below the
top margin.
The range is 1-255, and the factory default is 66.
Emulation Submenus
To Next Page
Loading...
Need help?
General
