242
Chapter 3 Emulation Submenus
Text Position
(From page 192, page 194, page 196, page 198, page 200.)
Specifies where the text will be positioned in the line space.
• Top of Line. Text is positioned at the top of the line space.
• Bottom of Line (the default). Text is positioned as if it were at the bottom
of a 6 lpi line space. The following example shows both Top of Line and
Bottom of Line text positions:
Top Margin
(From page 191, page 193, page 195, page 197, page 199.)
Defined in linespaces, starting from line zero at the top of the page and
incrementing from the top down.
The range is 0-451 linespaces, and the factory default is 0 linespaces.
Translate Table
(From page 168.)
• Default (the default). The option is disabled. The table is not stored in the
real translation table until the option is enabled.
• Downloaded. The option is enabled. The LU3 Translation Table is
loaded from the buffer into the permanent table.
Translation Tbl (Coax, TN3270)
(From page 167, page 179) Prints out SCS and DSC/DSE tables of the coax
interface's current character set. This operation is valid only when the coax
interface is selected as the current interface.
Translation Tbl (SPC Coax)
(From page 173.) Prints out a table of the coax interface's current character
set. This operation is valid only when the coax interface is selected.
Top of Line Space
Dot
Row
Bottom of 8 LPI Line Space
Bottom of 6 LPI Line Space
Text Position
Top of Line
Text Position
Bottom of Line
To Next Page
Loading...
Need help?
General
