Overview
225
Host Form Length (IPDS)
(From page 175.) Enables or disables changing the form length by the host.
• Disable. The host is unable to change the form length.
• Enable. The host may change the form length.
The factory default is Disable.
Host Form Length (VGL)
(From page 187.) Sets the printer page size.
• Enable. Sets the printer label size equal to Label Length from the host
form length command. (For more information, refer to the
IGP/VGL
Programmer’s Reference Manual
.)
• Disable. Sets the printer label size equal to the Label Length set in the
front panel under the PRINTER CONTROL menu.
The factory default is Enable.
Host Override
(From page 168, page 170, page 180, page 182.) Determines whether the
printer accepts certain commands sent by the host, or continues to use the
current operator panel settings.
• Disable. Allows these host commands to override operator panel
settings: line length, forms length, lines per inch (LPI), characters per inch
(CPI), print quality, and text orientation. Note the information appearing on
the message display may not match the data stream setting. No values
will change upon initial selection of the Disable option.
• Enable. The operator panel settings override the host commands.
The factory default is Disable.
Host PI
(From page 189.)
• Disable. The host does not send PI signals.
• Enable. The host sends PI signals. The Data Bit 8 configuration option
must be disabled to transmit the PI line to the printer.
The factory default is Disable.
Emulation Submenus
To Next Page
Loading...
Need help?
General
