Overview
243
Translation Tbl (SPC Twinax)
(From page 174.) Prints out a table of the twinax interface's current character
set. This operation is valid only when the twinax interface is selected.
Translation Tbl (TN5250, Twinax)
(From page 170, page 182.) Prints out a table of the twinax interface’s current
character set. This operation is valid only when the twinax interface is the
current interface.
True Vert 1/10
(From page 187.)
• Disable (the default). When disabled and in High Resolution, a vertical
line’s length in one inch and 1/10 inch increments is interpreted as 70/72
inch and 7/72 inch respectively.
• Enable. When enabled, a vertical line’s length is interpreted exactly,
which is 72/72 inch in one inch increments.
Trunc Dyn Data
(From page 184.)
This submenu allows the user to truncate the dynamic data up to the
maximum data length specified in Create Mode.
• Disable (the default). If the dynamic data exceeds the maximum data
length, an error will report.
• Enable. If the dynamic data exceeds the maximum data length, the data
truncates.
Truncate Alpha
(From page 187.)
• Enable (the default). Prevents the printing of Error 48 (Element Off Page
Error) if alphanumeric data, including spaces, extends beyond the right
side of the form.
• Disable.
Twinax Type
(From page 170.) This parameter defines the printer emulation as follows:
• IPDS 256 Bytes (the default)
• IPDS 1024 Bytes
• 5225
• 4234
After the emulation has been changed, a POR status is sent to the host.
Emulation Submenus
To Next Page
Loading...
Need help?
General
