IBM InfoPrint 6700 Series

32
Chapter 1 Setting Up The Printer
Setting Up The Printer
Unpacking The Printer
The printer is shipped in a carton and protective bag. The top lid of the carton
has instructions for removing the internal packing material. Keep all packing
material in case repacking is required.
ATTENTION Avoid touching the electrical connectors to prevent electrostatic
discharge damage while setting up the printer. The discharge of
accumulated electrostatic energy can damage or destroy the printhead
or electronic components used in this device.
ATTENTION Do not place the printer on its backside during unpacking or handling,
because you may damage the printer interface connector.
1. Remove the tape strips from the media cover. Lift open the media cover.
2. Remove the tape securing the foam pad to the inside of the media cover.
3. Remove the foam pad between the front door and the frame.
Tape Strips (2)
Foam Pads (2)
Media Cover
Frame