IBM InfoPrint 6700 Series User Manual

Specifying A Power-Up Configuration
91
NOTE: If the configuration number has been previously saved and Protect
Configs. = Enabled under CONFIG CONTROL, the following error
message displays:
If the above occurs, see “Modifying A Saved Configuration” on page 92,
step 4.
5. Print your configuration and store it in a safe place for future reference.
Refer to “Printing A Configuration” on page 93.
Specifying A Power-Up Configuration
You can specify any one of the nine configurations (1-8 or Factory) as the
power-up configuration:
1. Press the key until the following message displays:
2. Press the ↓ key until the following message displays:
3. Press the
+ or − key to cycle through the options (1-8 and Factory). When
the desired number displays, press the ↵ key to select it. The following
message displays:
NOTE: If the configuration number has not been saved previously, the
following error message displays:
If this error message displays, see “Saving A Configuration” on
page 90. Once you have saved a configuration, repeat the steps in
this procedure.
CONFIG. EXISTS
Delete First
.
.
.
MENU MODE
CONFIG. CONTROL
Power-Up Config.
1*
Power-Up Config.
X *
CONFIG. DOES NOT
EXIST/Save First

IBM InfoPrint 6700 Series Specifications

General

Brand	IBM
Model	InfoPrint 6700 Series
Category	Printer
Language	English