To Next Page

To Previous Page

Changing Printer Settings

IMPORTANT

This change takes effect for all subsequent data and operations for the

printer as soon as the ↵ key is pressed and the asterisk (*) is displayed.

The configuration change(s) stay in effect only while the printer is

powered on. When the power is turned off, all current configurations will

be lost unless changes made to it are saved via the CONFIG. CONTROL

menu.

To save configuration information permanently or to select it as the power-up

default, see “Saving A Configuration” on page 90.

Changing Printer Settings

You can change (or “configure”) printer settings, such as print speed or

emulations, through the control panel as follows:

1. Press the key until the following message displays:

2. Press the ↓ key to cycle through these options:

• Print Intensity

• Print Speed

• Print Mode

• Media Handling

• Paper Feed Shift

• Label Length

• Label Width

• Ver Image Shift

• Hor Image Shift

• Orientation

• Gap/Mark Sensor

• Auto Calibrate

• Validator (if installed)

• Active IGP Emul

• Save Config.

• Power-Up Config

• SMT

3. When the desired submenu displays, press the

+ or − key to scroll

through the values or options.

MENU MODE

QUICK SETUP

IBM InfoPrint 6700 Series User Manual

Questions and Answers: