WIRELESS ADDRESS Submenus
273
WIRELESS ADDRESS Submenus
IP Address
This item allows you to set the IP Address for the TCP/IP protocol in four
three-digit segments (SEG1 through SEG4). If the IP Address is assigned by
Bootp, ARP or DHCP, it is dynamic and read-only.
The factory defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
When changing the IP Address, the printer resets the Ethernet when the
printer is placed online. When the printer resets the Ethernet, the LCD
displays DO NOT POWER OFF. After the Ethernet has completed its
initialization, the LCD displays E-NET INIT to signal that the Ethernet and
printer are in the initialization process. When both the Ethernet and printer
have completed initialization, the LCD displays E-NET READY.
Subnet Mask
This item allows you to set the Subnet Mask for the TCP/IP protocol in four
three-digit segments (SEG1 through SEG4). If the Subnet Mask is assigned
by Bootp, Arp or DHCP, it is dynamic and read-only.
The factory defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
When changing the Subnet Mask, the printer resets the Ethernet when the
printer is placed online. When the printer resets the Ethernet, the LCD
displays DO NOT POWER OFF. After the Ethernet has completed its
initialization, the LCD displays E-NET INIT to signal that the Ethernet and
printer are in the initialization process. When both the Ethernet and printer
have completed initialization, the LCD displays E-NET READY.
Gateway Address
This item allows you to set the Gateway Address for the TCP/IP protocol in
four three-digit segments (SEG1 through SEG4). If the Gateway Address is
assigned by Bootp, ARP or DHCP, it is dynamic and read-only.
The factory defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
When changing the Gateway Address, the printer resets the Ethernet when
the printer is placed online. When the printer resets the Ethernet, the LCD
displays DO NOT POWER OFF. After the Ethernet has completed its
initialization, the LCD displays E-NET INIT to signal that the Ethernet and
printer are in the initialization process. When both the Ethernet and printer
have completed initialization, the LCD displays E-NET READY.
To Next Page
Loading...
Need help?
General
