140
Chapter 3 MEDIA CONTROL
When Clip Page is set to Disable, the printer ignores any pre-printed dark
marks or multiple gaps on a label that could mistakenly be detected as
the next top-of-form position based on the specified Label Length value.
The Label Length option is in the MEDIA CONTROL menu.
NOTE: When Clip Page = Disable, the correct Label Length value must be
entered. If the value is too long, the printer will ignore the actual gap
or mark it needs to detect. When using Gap sensing, the Label
Length value is equal to the physical length of a die cut or removable
label. When using Mark sensing, the Label Length value is the
physical distance from the leading edge of one black mark to the
leading edge of the next black mark.
The factory default for Clip Page is Enable.
Error Recover
This option determines how the printer handles data that was printing when
an error occurred.
• Disable. The printer will not reprint the label that was printing when the
error condition occurred.
• Enable. The printer reprints the label that was printing when the error
condition occurred.
The factory default is Disable.
Ribbon Width
When Same As Paper is selected, the printer automatically adjusts the ribbon
operating parameters to match the installed media width. In those cases
where the media width is less than the installed ribbon width, the Set In Menu
option should be selected. After selection, the ribbon width is set to the proper
value by pressing the ↓ key and choosing the actual ribbon width using the +
and − keys. The chosen width is then selected by pressing the ↵ key. The
factory default is Same As Paper.
Display Ribbon
When enabled and the printer online, 1 to 4 asterisks will display on the LCD
indicating the approximate amount of ribbon remaining on the supply spindle:
Online Rbn **** = 470 to 625m
*** = 314 to 469m
** = 157 tp 313m
* = 1 to 156m
The options are Enable (the factory default) and Disable.
To Next Page
Loading...
Need help?
General
