PRINTER CONTROL Submenus
157
Power-up State
• Online. The printer powers up in the online state.
• Offline. The printer powers up in the offline state. This selection must be
saved as a power-up configuration to be used.
The factory default is Online.
Ptx Setup SFCC
Allows you to choose the hex value of the ASCII character you wish to use as
the SFCC for the PTX SETUP command. Valid hex values are 01-FF.
The factory default value is hex 21, which corresponds to the “!” character.
Overwrite Files
This allows you to prevent files from being overwritten by disabling the
overwrite function.
The options are Enable (the factory default) and Disable.
View File List
Displays the list of files in the file system. Pressing ↓ displays the file size.
Delete Files
Allows you to delete files in the file list. Contact your administrator for
assistance.
Flash Avail.
The amount of flash available for the user to save or download files into flash.
Optimize&Reboot
Reclaims flash space from deleted flash files. After pressing ↵ wait for the
printer to reboot.
Print File List
Prints a summary of the files stored in flash memory and several statistics on
File System usage.
Cancel Key
• Disable.
• Enable. When enabled, the
key may be used in offline mode to clear
all data in the print buffer, and deleted data will not be printed.
The factory default is Disable. When the Coax/Twinax interface is installed,
the factory default is Enable.
To Next Page
Loading...
Need help?
General
