IBM InfoPrint 6700 Series User Manual

196
Chapter 3 SER MATRIX SETUP
Define CR code
(page 214)
CR = CR* CR = CR + LF
Control Code 06
(page 212)
Define LF code
(page 215)
LF = LF* LF = CR + LF
8.0 LPI* 10.3 LPI 6.0 LPI
Bold
(page 205)
Disable* Enable
Overstrike
(page 231)
Enable* Disable
Printer Select
(page 234)
Disable* Enable
Alt. Set 80-9F
(page 202)
Control Code* Printable
1
ESC d command
(page 218)
Even dot plot* Double high
SER MATRIX SETUP
(cont. from prev. page)
Text Position
(page 242)
Bottom of Line* Top of Line
Auto LF
(page 203)
Enable* Disable
Reset Cmd CFG Ld
(page 236)
Disable*
Host Command
(page 224)
Enable* Ignore All Ignore CPI Ignore LPI
Power up config Current config Factory config
Form Length
2, 3
(page 220)
Form Length
2, 3
(page 220)
101.6 or 152.4 mm*
4
Form Length
2
(page 220)
Form Width
5
(page 221)
41, 66, or 85 characters*
4
0 to 272 characters
00.0 to 609.6 mm
4 or 6 inches*
4
00.0 to 24.0 inches
24 or 36 lines*
4
0 to 144 lines
Form Width
3, 5
(page 221)
104.1, 168.0, or 215.9 mm*
4
00.0 to 345.4 mm
Form Width
3, 5
(page 221)
04.1, 06.6, or 08.5 inches*
4
00.0 to 13.6 inches
Notes:
* = Factory Default
1
When the CTHI option is installed,
the factory default is Printable.
2
All three Form Length submenus
work in conjunction. When you
change the default in one
submenu, the default values in the
other two submenus change
automatically.
3
These menus do not display when
the CT, TN5250, or TN3270
emulation is selected.
4
The factory default value depends
on the width of the printer model.
5
All three Form Width submenus
work in conjunction. When you
change the default in one
submenu, the default values in the
other two submenus change
automatically.

IBM InfoPrint 6700 Series Specifications

General

Brand	IBM
Model	InfoPrint 6700 Series
Category	Printer
Language	English