202
Chapter 3 Emulation Submenus
Absorb After ^PY
(From page 187.)
• Absorb Motion. The paper motion line terminator immediately following
the graphics ^PY command will be ignored.
• Absorb All. The system ignores all the data following ^PY until a host
generated terminator is detected and ignored.
• Disable. System terminators following a graphics command are sent to
the printer and result in paper motion.
The factory default is Absorb Motion.
Active Char Set
(From page 167, page 170, page 179, page 182.) Selects which group of
character sets (Primary or Secondary) will be active.
The factory default is Secondary Set.
AI 00 Spaces
(From page 185.) This option is designated for EAN/UCC-128 barcodes
whose application identifier (AI) is 00.
• Disable. The printable data field is printed with the AI enclosed in
parentheses. This is the standard EAN/UCC-128 format.
• Enable. The printable data field is printed with the UCC fields separated
by spaces. This option is IGP-X00 compatible.
The factory default is Disable.
Alt. Char Set
(From page 198.)
• Set 1. Interprets data in the range of hex 80 through hex 9F as a control
code.
• Set 2. Prints data in the range of hex 80 through hex 9F.
The factory default is Set 1.
Alt. Set 80-9F (P-Series, Serial Matrix, Epson FX)
(From page 191, page 196, page 200.)
• Control Code. Interprets data in the range of hex 80 through hex 9F as a
control code.
• Printable. Prints data in the range of hex 80 through hex 9F.
The factory default is Control Code. However, when the CTHI option is
installed, the factory default is Printable.
To Next Page
Loading...
Need help?
General
