230
Chapter 3 Emulation Submenus
Logical Buf Size
(From page 173.) Refers to the size of the printer buffer, which should be set
the same as the host screen (buffer) size. If the host screen size is unknown,
use 1920.
The options are 960, 1920, 2560, 3440, and 3564.
The factory default is 1920.
LPI
(From page 187.) This item selects the number of lines printed per inch.
The range is 6-10, and the factory default is 6.
Max PI 16
(From page 189.)
• Enable. A paper slew of 0-15 will move 1-16 lines.
• Disable. A paper slew of 1-15 will move 1-15 lines. A paper slew of 0 will
always move 1 line.
The factory default is Enable.
Max. Print Width
(From page 168, page 170, page 180, page 182.) Set the maximum print
width the printer will print when using a C/T or TN5250 host interface. Set for
13.2 inches when printing files larger than the width of the printer. All data
exceeding the width of the maximum Printer Width will be truncated.
• 13.2 inches
• Printer Width (the maximum width of the printer)
The factory default is 13.2 inches.
Midline PY (includes ^PN)
(From page 188.)
• Disable. The Graphics mode Enabled command, ^PY, must be the first
three characters of a line.
• Enable. The ^PY or ^PN can occur anywhere in a line.
The factory default is Disable.
NL at MPP+1
(From page 167, page 173, page 179.) Specifies the linespacing action when
the printline exceeds the rightmost print position and text continues from the
leftmost print position on a new line.
• On (the default). Moves to the first print position two lines down from the
current position.
• Off. Moves to the first print position of the next print line.
To Next Page
Loading...
Need help?
General
