Overview
245
Upr. Case Select
(From page 194.) Controls how the printer handles lowercase characters it
receives from the host computer. When enabled, all characters are printed in
uppercase.
• Disable (the default). Prints lowercase characters received from the host
computer as lowercase; prints uppercase characters received from the
computer as uppercase.
• Enable. Prints lowercase characters received from the host computer as
their corresponding uppercase equivalents; prints uppercase characters
received from the computer as uppercase.
User-Def Ratio
(From page 185.) This option allows you to ignore the user-defined barcode
ratio and replace it with the default ratio (X1).
• Enable (the default). Allows the user-defined barcode ratio.
• Disable. The user-defined barcode ratio will be replaced with the default
ratio (X1).
User-Defined St1 (Start Code 1)
(From page 168, page 170, page 173, page 174, page 180, page 182.) This
option allows you to define your own value (in ASCII characters) for the User
Defined option in the Lead-in Chars menu. “St1” specifies Start Code 1. See
“Lead-in Chars” on page 229 for additional information.
The range is 40 - FF, and the factory default is 5F.
User-Defined St2 (Start Code 2)
(From page 168, page 170, page 173, page 174, page 180, page 182.) This
option allows you to define your own value (in ASCII characters) for the User
Defined option in the Lead-in Chars menu. “St2” specifies Start Code 2. See
“Lead-in Chars” on page 229 for additional information.
The range is 40 - FF, and the factory default is 5F.
User-Defined Stp (Stop Code)
(From page 168, page 170, page 173, page 174, page 180, page 182.) This
option allows you to define your own value (in ASCII characters) for the User
Defined option in the Lead-in Chars menu. “Stp” specifies Stop Code. See
“Lead-in Chars” on page 229 for additional information.
The range is 40 - FF, and the factory default is 5B.
Emulation Submenus
To Next Page
Loading...
Need help?
General
