WIRELESS PARAMS Submenus
281
Ant. Diversity
The type of antenna used:
• Diverse (the default). Select when you want to use the antenna with the
best reception.
• Primary. Select when you want to use the Primary antenna on the server.
• Auxiliary. Select when you want to use the Auxiliary antenna on the
server.
Preamble
The length of the preamble in transmit packets.
• Default (the default). The Wireless option automatically determines the
length.
• Short. For newer printers which can handle higher transfer rate speeds.
• Long. For older printers, which cannot handle higher transfer rate
speeds.
Power Mgmt
This allows you to set power-save mode and sleep time. A value specifying
the sleep time in milliseconds will be provided. If set to zero, power-save
mode will be disabled.
The range is 0-1000 ms., and the factory default is 0 ms.
Internat. Mode
When enabled, the Wireless option adapts to international frequency
requirements in Europe.
The options are Disable (the factory default) and Enable.
Auth Method
This feature allows the user to select the authentication method used for the
wireless network interface.
• Open (the default). Selects open authentication.
• Shared. Selects shared key authentication.
• LEAP. Selects LEAP authentication (for use with a Cisco RF card
installed).
Transmit Power
The power level as a percentage of full power.
The range is 0 - 100%, and the factory default is 100%.
To Next Page
Loading...
Need help?
General
