IBM pSeries 630 6C4

8. Replace the media support shelf. Tighten the thumbscrew located on the support
shelf.
Note: When replacing the support shelf, ensure that the lower support leg, located
on the bottom side of the support shelf, activates the microswitch located on
the CEC backplane. Failure to do so results in the system not being able to
power-on.
9. Replace all removed media drives, ensuring that the media drives removed are
returned to the same media bay locations from which they were removed. Refer to
“Media Drive Replacement” on page 103.
10. Reconnect all power and signal cables to their respective media drives.
11. Replace the front bezel as described in “Front Bezel Replacement (Model 6C4)” on
page 62 or “Front Bezel Replacement (Model 6E4)” on page 63.
12. Replace the service access cover as described in “Service Access Cover
Replacement (Model 6C4)” on page 55 or “Service Access Cover Replacement
(Model 6E4)” on page 58.
13. On a Model 6C4, push the system drawer back into the operating position as
described in “Returning the Model 6C4 to the Operating Position” on page 54.
14. Power on the system as described in “Starting the System” on page 52.
15. If the Model 6C4 has successfully powered on, close the rack doors.
If the Model 6E4 has successfully powered on, close the bezel door.
112 Eserver pSeries 630 Model 6C4 and Model 6E4 Installation Guide