IBM pSeries 630 6C4

Repair Action
After you have determined which component is failing, a repair action is necessary.
1. Run the system verification procedure. Refer to Chapter 4, “Installing Options for the
Model 6C4 and Model 6E4” on page 49 for instructions on component installation,
removal and replacement.
2. Record the following information:
v Machine type and model
v Server serial number
v Any error codes that appear in the operator panel display or console
v Any LEDs that are lit on the indicator panel
3. Call for service.
4. After the repair action is completed, go to “Resetting the LEDs”, and reset the
LEDs.
Resetting the LEDs
After the repair action is completed, do the following:
1. Log in as root user.
2. At the command line, type diag.
3. Select Task Selection.
4. Select Log Repair Action.
5. Select the device that was repaired.
6. Press F10 to exit diagnostics.
If the Attention LED remains on after you have completed the repair action and reset
the LEDs, call for service.
144 Eserver pSeries 630 Model 6C4 and Model 6E4 Installation Guide