15. Replace all media drives, ensuring that the media drives removed are returned to
the same media bay from which they were removed as described in “Media Drive
Replacement” on page 103.
16. Reconnect all power and signal cables to their respective media drives.
17. Replace the front bezel as described in “Front Bezel Replacement (Model 6C4)” on
page 62 or “Front Bezel Replacement (Model 6E4)” on page 63.
18. Replace the service access cover, as described in “Service Access Cover
Replacement (Model 6C4)” on page 55 or “Service Access Cover Replacement
(Model 6E4)” on page 58.
19. If you are servicing a Model 6C4, push the system drawer back into the operating
position as described in “Returning the Model 6C4 to the Operating Position” on
page 54.
20. Turn on the system power. The 28030002 error code indicates invalid time and
date values in NVRAM, and can be ignored at this time; the bad time and date
values are the result of changing the battery. When AIX starts to load, this error
code will be cleared from the operator panel.
If the system fails to load AIX, it may be necessary to set up the boot list again
using the System Management Services. Refer to the eserver
pSeries 630 Model
6C4 and Model 6E4 User’s Guide
.
21. Reset the time and date. After date and time have been reset, it is advisable to
reboot the system, to ensure all process have a similar date and time.
22. If you are running AIX, the bootlist command may need to be run while logged in
as root user. This action rebuilds the customized boot list. IP (Internet protocol)
parameters may also need to be reentered.
Chapter 4. Installing Options 123
To Next Page
Loading...
Need help?
General