IBM Storwize V7000 Unified Series User Manual

Table 46. Upgrade error codes and recommended actions (continued)
Error
Code Explanation Action
01AB Internal upgrade error in
node_setup_system.
Contact your next level of support.
01B1 Management node replication
failed.
1. Go to “Resolving issues reported for
lshealth” on page 168.
2. Contact your next level of support.
01B2 Unable to start performance
collection daemon.
Contact your next level of support.
01B3 Failed to copy upgrade package to
Storwize V7000.
This could be caused by a number of
issues. Check Monitoring > Events under
both the block tab and the file tab on the
management GUI for an event that could
have caused this error and follow the
recommended action. If there is no
obvious event that could have caused
this error, refer to “File module to control
enclosure” on page 27.
01B4 Failed to start upgrade on Storwize
V7000 with the applysoftware
command.
This could be caused by a number of
issues. Check Monitoring > Events under
both the block tab and the file tab on the
management GUI for an event that could
have caused this error and follow the
recommended action. If there is no
obvious event that could have caused
this error, refer to “File module to control
enclosure” on page 27.
01B5 Storwize V7000 multipaths are
unhealthy.
Check the Fibre Channel connections to
the system. Reseat Fibre Channel cables.
For more information, see "Mounting a
file system" in the IBM Storwize V7000
Unified Information Center.
01B6 System volumes are unhealthy as
indicated by using the lsvdisk
command.
See Chapter 5, “Control enclosure,” on
page 173.
01B7 Failed to query status of upgrade
by using the
lssoftwareupgradestatus
command.
This could be caused by a number of
issues. Check Monitoring > Events under
both the block tab and the file tab on the
management GUI for an event that could
have caused this error and follow the
recommended action. If there is no
obvious event that could have caused
this error, refer to “File module to control
enclosure” on page 27.
01B8 Failed to query status of Storwize
V7000 nodes by using the svcinfo
lsnode command.
See Chapter 5, “Control enclosure,” on
page 173.
Chapter 7. Recovery procedures 269

IBM Storwize V7000 Unified Series Specifications

General

Brand	IBM
Model	Storwize V7000 Unified Series
Category	Storage
Language	English