Table 46. Upgrade error codes and recommended actions (continued)
Error
Code Explanation Action
01D3 Could not determine if backups are
running.
Type lsjobstatus -j backup;echo $?.If
the return code is 0, start the upgrade
again. If the return code is any other
number, contact your next level of
support.
01D5 Storwize V7000
stalled_non_redundant.
Contact your next level of support.
01D6 Storwize V7000 system stalled. Contact your next level of support.
01D8 CTDB system is unhealthy. See “Checking CTDB health” on page
160.
01DA GPFS system is unhealthy. See “Checking the GPFS file system
mount on each file module” on page 162.
01DB Failed to stop performance center. Contact your next level of support.
01DC Failed to configure performance
center.
Contact your next level of support.
01DD Failed to start performance center. Contact your next level of support.
01DE Unable to communicate with
passive management node.
Verify that the other management node is
up and that TCP/IP communication is
working. Then start the upgrade again.
01DF Upgrade must be resumed from the
other management node.
Start the upgrade again from the other
management node. This might require
that a failover be issued first.
01E0 HSM upgrade failed. Contact your next level of support.
Chapter 7. Recovery procedures 271
To Next Page
Loading...
Need help?
General