Icom IC-41W - Group and Priority Scan Modes

19
6
SCAN
6
Group and Priority Scan ■
Group and priority scans repeatedly watch a priority chan-
nel while scanning the specified tag channels. This is useful
when waiting for a call on the priority channel.
Group and priority scans behave differently when transmit-
ting. Group scan allows the user to transmit on a busy or
priority channel. Priority scan will only allow transmission on
a priority channel. (or the channel scanning starts ON, if no
priority channel is set)
To initiate a group or priority scan:
Push q
until group or priority scan is selected.
•“
” appears when group scan is selected, and “ ” appears
when priority scan is selected.
Priority scan is selected.Group scan is selected.
Appears
Appears
Set the priority channel by holding down w for 2 sec-
onds while on the desired channel.
•
To cancel the priority channel, push [Top] to enter second func-
tion mode, then push and hold to remove the priority set-
ting.
e
Appears
Push to start the scan.
Blinks
BlinksGroup scan starts.
Priority scan starts.
Priority channel
Scan start channel
r When receiving a signal, the scan will pause and resume
according to the selected scan resume condition.
t Push
to cancel the scan.