20
6
SCAN
Repeater ■
The repeater search scan is not only used to search for a sig-
nal on the repeater channels, but also to access a repeater by
transmitting automatically in sequence. The repeater search
function searches available repeaters in the area .The re-
peater scan detects signals on repeater channels. When the
repeater is not busy, it will be available for use. The repeater
scan will stop should any activity be detected (The scan is
cancelled when receiving a signal, such as stations commu-
nicating in simplex operation on a repeater output channel).
•ExcludesemergencyrepeaterchannelCB-R5.
To start the repeater scan:
Select the desired repeater output channel and push and q
hold
for 2 seconds to start the repeater scan.
w When a signal is received on the repeater channel, scan-
ning will stop. (during the second cycle scanning the re-
peater channels, three high beeps will sound when a sig-
nal is received, and three low beeps will sound when no
signal is received)
Push e
to cancel the scan manually. (when transmitting,
the repeater scan cannot be cancelled)
Repeater search scan flow D
Scan
Scan
Searches for sig-
nal on the repeater
output channels.
Access to the repeater
automatically. (0.5 sec.)
Wait for a signal from
the repeater. (0.5 sec.)
Access to the next
repeater automatically.
(When no reply signal is received.)
Scan is cancelled automatically.
Scan start
channel
Appears
Appears
NOTE: Excludes Emergency Repeater ‘CB-R5.’
To Next Page
Loading...
Need help?
General
