Icom IC-41W - TX Code Number Edit and Individual Calls

25
8
SELCALL (Selective Calling)
8
TX code number edit D
“ ” enables the user to change the TX code digits contained
in the TX code channel. The group call function works by al-
lowing the user to edit a special ‘group code’ into the last 2
digits of the SelCall ID code.
To edit a TX code:
Select the desired CB channel (CB-XX) except channels q
5 and 35.
Push [Top] to enter function mode, then push w
to en-
ter the TX code channel selection mode. If desired, push
[CH Up] or [CH Down] to select the required TX code
channel.
Push and hold e
for 2 seconds again to enter the TX
code edit mode.
The editable digit starts blinking
r Push to select the desired digit to be edited.
t Push [CH Up] or [CH Down] to set the desired code. Se-
lect ‘
✱’ when group code is set.
y Push
to set the digit and move to the next editable
digit.
u Repeat step t and y to input all digits.
i After setting the final digit, push
to set the code and
return to the TX code channel selection mode.
o Push [PTT] to transmit the selected TX code channel, or
push
to set the selected TX code channel and return
to the stand-by mode.
Appears
Transmitting
NOTE: the allowed editable digits can only be set via the
CS-41S
c l o n i n g s o f t w a r e . (optional)
To transmit an individual call:
Push [Top] to enter function mode, then push and hold ➥
for 2 seconds to transmit.
Appears
Transmitting