Icom IC-7100

11
MEMORY OPERATION
11-6
Previous view
Programming a Memory channel (Continued)
Programming in the DR mode D
Push q
DR
to select the DR mode. (p. ??-??)
Set the desired contents. w (p. ??-??)
Push e
MENU
(C) one or more times to select the “D-
2” screen.
Touch [MW]( r D).
• The “MW” screen appears.
Rotate [BANK]( t L) or [M-CH](L) to select the Mem-
ory channel to be programmed.
• “---.---.-- ------” appears when no content has been pro-
grammed into the Memory channel. (Blank channel)
Touch [MW]( y D) for 1 second to program the con-
tents into the Memory channel.
Check the programmed contents on the Memory u
mode. (p. ??-??)
For your reference ✓
The Memory channel contents, programmed in the DR
mode, can also be copied to the VFO. (p. ??-??)
The L, R, C or D in the instructions indicate the part of
the controller.
L: Left side, R: Right side, C: Center bottom
D: Display (Touch panel)
Set the
desired
contents.
Blinks
Touch
[MW]
Touch
[MW] for
1 second
DR
MENU
[Example]:
Programming
“HIRANO43”
in “FROM”/
“HAMACH43”
in “TO” into
Memory
channel A-01.
[BANK]/
[M-CH]