ICT Protege PRT-KLCD - Page 42

42 PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011
The display will show the schedule programming. A schedule defines when this menu group will be valid. A
setting of none will disable schedule verification. Use the [1] and [3] keys to scroll the records. The arrow Î on
the top line indicates it is a scroll selection entry screen.
MG010 SecondaryÎ
None
The display will show the secondary menu group selection. A secondary menu group if programmed will be used
if the assigned schedule is not valid. This allows an access level to be assigned menu groups based on the time
of the day. By default this is set to None and is disabled if a schedule of None is programmed. Use the [1] and [3]
keys to scroll the records. The arrow Î on the top line indicates it is a scroll selection entry screen.
The display will show the option entry screen for the main menus that the menu group will allow access to.An
option can be toggled on and off by using the numerical keys [1] to [8]. To view the options in text entry mode
press the [STAY] key.

(1) Area Control Menu
Setting the area control menu option allows the menu group to access [MENU,1].

(2) User Programming Menu
Setting the user programming menu option allows the menu group to access [MENU,2]. Some restrictions apply
to the sub menus see sub menu options.

(3) Event Review Menu
Setting the event review menu option allows the menu group to access [MENU,3].

(4) Installer Menu
Setting the installer menu option allows the menu group to access [MENU,4]. It is not recommended any menu
groups other than the installer menu group has this enabled.

(5) View Menu
Setting the view menu option allows the menu group to access [MENU,5].

(6) Time Settings Menu
Setting the time settings menu option allows the menu group to access [MENU,6]. Some restrictions apply to
the sub menus of the time settings.

(7) Bypass Zones Menu
Setting the bypass zones menu option allows the menu group to access [MENU,7]. Some restrictions apply to
the sub menus of the bypass zone settings.
