Ideal Heating EVOMAX 2 - 3.8 Menu - DHW

19
3.7.16 Menu – Heating Circuit –
Settings – Frost protection
Heatingcircuitfrostprotectionoperationcan
be triggered by a number of measured real
timevalues:
Frost protection
Flow temperature
Outside temperature
Room temperature
Eachofthesehasatriggersetpointanda
hysteresis value above which the function
is once again deactivated. E.g. Room
temperature,iftheactualroomtemperature
dropsbelowthetemperaturesetpointvalue
thenHeatingCircuitwillcreateademandinto
thesystem.Itwillonlyremovethisdemand
oncetheactualroomtemperaturehasrisen
abovethisvalue,plusthehysteresissetting.
Room temperature
Temperature
Hysteresis
Temperature
6ºC
Hysteresis
2ºC
3.7.17 Menu – Heating Circuit –Time
clock
Each heating circuit can have its own
individual time programme. Refer to the
Plantsectionforguidanceonhowthisisset.
3.7.18 Menu – Heating circuit –
Holiday programme
Each heating circuit can have its own
individualholidayprogrammes.Refertothe
Plantsectionforguidanceonhowthisisset.
3.8 Menu – DHW
DHW
Status
Operating mode
Tank temperature
DHW
Status
Operating mode
Tank temperature
Settings
DHW
Operating mode
Tank temperature
Settings
Time clock
DHW
Tank temperature
Settings
Time clock
Holiday program
DHW
Settings
Time clock
Holiday program
DHW
Time clock
Holiday program
3.8.1 Menu – DHW - Status
Thestatussubmenugiveyouaccesstosee
thecurrentrealtimevaluesoftheDometic
HotWatercircuits.
Thestatusmenuhasthefollowingoptions:
Status
Summary
Real time values
3.8.2 Menu – DHW – Status - Summary
Thesummarysubmenuliststhecongured
Dometic Hot Water circuits that are
conguredandcanbeselected,whichthen
showsthemainvaluesfortheDomesticHot
Watercircuit.
Summary
DHW1 Boiler 1
DHW1Boiler 1
Status: Standby
Tank temperature: 21.1ºC
Flow setpoint: 23.0ºC
Pump speed: 0 %
3.8.3 Menu – DHW – Status – Real
time values
TheRealtimevaluesmenuhasthefollowing
options:
Real time values
Demand inputs
Sensors
Outputs
Real time values
Inputs
Sensors
Outputs
Real time values
Sensors
Outputs
3.8.4 Menu – DHW – Status – Real time
values – Demand inputs
Onceinputsisselectedthescreenwillshow
the congured list of Domestic Hot Water
circuits:
Demand inputs
DHW1 Boiler 1
Once a DHW circuit is selected, then the
following screen will display the current
RealtimevaluesfortheconguredInputs,
onceagainitemsthatarenotconguredwill
beshownwithnovaluebutwith2dashes
to indicate this, the list can be scrolled if
requiredtoshowallvalues:
DHW1 Boiler 1
SL2: On
OT1: - -
Tank setpoint: 8ºC
DHW1 Boiler 1
SL2: On
OT1: - -
Tank setpoint: 8ºC
Flow setpoint: 8ºC
DHW1 Boiler 1
OT1: - -
Tank setpoint: 8ºC
Flow setpoint: 8ºC
DHW1 Boiler 1
Tank setpoint: 8ºC
Flow setpoint: 8ºC