IEI Technology TANK-820-H61 Series User Manual

TANK -820-H61 E mbedded S ystem
Page 28
3.7.5 Digital Input/Output C onnector
The digital I/O connector provides programmable input and output for external devices.
The pinouts for the digital I/O connector are listed in the table below.
Figure 3-14: DIO Connector
3.7.6 DVI C onnector
The TANK-820-H61 has one female DVI-I connector on the front panel. The DVI
connectors are connected to digital display devices. To connect a digital display device to
the TANK-820-H61, please follow the instructions below.
S tep 1: Locate the DVI connector. The location of the DVI connector is shown in
Chapter 1.
S tep 2: Align the DVI connector. Align the male DVI connector on the digital display
device cable with the female DVI connector on the external peripheral interface.
S tep 3: Insert the DVI connector. Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the TANK-820-H61. See Figure 3-15.

IEI Technology TANK-820-H61 Series Specifications

General

Brand	IEI Technology
Model	TANK-820-H61 Series
Category	Desktop
Language	English