28
10.3.8 Reset all parameters to factory setting
► Change to [EF]�
► Select [rES] with the "up" or "down" button, then press [Enter]�
> [ rE] is displayed�
► Keep the "up" or "down" button pressed until [---] is displayed�
► Confirm with [ENTER]�
> All parameters are reset to factory setting�
re5
11 IO-Link
11.1 General information
This unit has an IO-Link communication interface which requires an IO-Link-
capable module (IO-Link master) for operation�
The IO-Link interface enables direct access to the sensor values and parameters
and provides the possibility to set the parameters of the unit during operation�
In addition, communication is possible via a point-to-point connection with a USB
adapter cable�
You will find more detailed information about IO-Link at www�ifm�com�
11.2 Device-specific information
You will find the IODDs necessary for the configuration of the IO-Link unit and
detailed information about sensor values, diagnostic information and parameters
in the overview table at www�ifm�com�
11.3 Parameter setting tools
You will find all necessary information about the required IO-Link hardware and
software at www�ifm�com�
11.4 Functions
With IO-Link all functions and measured data are available that can also be
accessed via the display and pushbuttons on the unit�
The process data value includes the measuring distance and the object reflectivity�
All functions are described in detail in the IODD�
12 Set-up / Operation
► After installation, electrical connection and programming, check whether the
unit operates correctly�
> If the unit has been correctly set up, the object distance or the object reflectivity
is indicated� The settings made last are internally stored by the sensor�
Lifetime of a laser diode: 50,000 hours
To Next Page
Loading...
