The StellarMate Plus Manual
67 / 341
Select the desired WiFi network from the list and press Connect. Enter and
double check the WiFi password. A final confirmation warning popup about
switching to WiFi infrastructure mode is displayed, press Yes to continue. The
App will command StellarMate to join the WiFi network and then begins to scan
for StellarMate in the local network. This assumes your phone/tablet will
automatically switch to your home WiFi network since it will be disconnected
from the hotspot and in most cases this causes Android/iOS to fall back to the
next available network. If this does not happen, then go to Network Settings in
your mobile OS and connect to the same WiFi network selected above.
This process can take up to 2 minutes. If successful, the device IP address is
going to change the new WiFi IP address. Go back to the setup page to make
sure the device is connected. If not, double click on the device to ensure it is
connected properly.
Once StellarMate is joined to a WiFi network, it will always try to connect to this
network unless it is out of range. In this case, it will default back to the HotSpot.
To Next Page
Loading...
