IMET M550 - Kversion

IMET - M550 ALL1-EN 21/53
5.5.3. K version
Make sure
that
introducing
the receiver
on the BUS
maintains the
line
impedance,
adjusted.
Options on request SYMBOL DESCRIPTION
POWER IN
Input for main power supply
GND
Ground connection input
F10
1.25A L250V power supply fuse
E- STOP
STOP relay connection
F12
T5A L250V E-STOP contact protection fuse
START
NO/NC relay output
HORN
Horn control output
T-STOP
Time-Stop relay connection
S-STOP
Safety-Stop relay connection
F11
T5A L250V S-STOP contact protection fuse
CAN-H
CAN-H line input
CAN-L
CAN-L line input
SERIAL
CONNECTION
CABLE
D0
DATA IN for RS232 serial
VIN=ENABLE
Input enabling RS232 (down active)
VOUT 10.7
10.7V DC Imax=250mA auxiliary voltage output
GND
Ground connection input
CAN−H
CAN−L
R1
R1 = CAN TERMINAL
EEPROM
E-STOP
SLOT PER INSERIMENTO SCHEDE
RF BUSY POWER SUPPLY
WORKING
DATA ERROR CH. B PASSIVE EMERGENCY CH. B DATA ERROR CH. A PASSIVE EMERGENCY CH. A
HORN C
HORN NC
TIMED STOP C
TIMED STOP NC
TIMED STOP NO
SAFETY STOP C
SAFETY STOP NO
HORN NO
ON
T5A
L250V
T5A
L250V
+12 ÷ 28Vdc IN
STROBE
AD3 IN
AD2 IN
AD1 IN
AD0 IN
+5V
GND
+10,7V
D7 ON/OFF IN
D6 ON/OFF IN
D5 ON/OFF IN
D4 ON/OFF IN
D3 ON/OFF IN
D2 ON/OFF IN
D1 ON/OFF IN
D0 ON/OFF IN - RX IN
COM ON/OFF IN
ACK
ERROR
+V IN
RS232
T1,25A
L250V
START NO
START NC
START C
E-STOP
GND
F10
E-STOP 1/2
SAFETY
STOP
DIPSWITCH
TIMED
STOP
HORN
START
F12
E-STOP 2/2
F11