34/53 IMET - M550 ALL1-EN
• From 1 to 8 for H receivers.
These outputs are activated with the Lock procedure and remain active even during work session
interruption caused by the transmitter switching off. To deactivate them it is necessary to carry out the
Unlock procedure or remove power to the receiver.
Any lack of power to the receiver will delete the priorities acquired by the transmitters. To reset the
desired conditions choose the desired combination with the rotating selector and subsequently a lock
procedure.
7.1.3. Anomalies
Some useful suggestions are given in this chapter, in addition to those in the main manual (Chap.9), in
case anomalies in the functioning of the radio controls with MtrS or MtrS Easy option are verified
(Chap. 6).
7.2. DSC Option
When the transmitting unit has the two toggle switches
represented in the image here on the right, it is possible to use the
DSC function.
Under normal operational conditions where the snail (reduced
speed) function is active, it may be necessary to temporarily
correct analogue output calibration values without having to enter
the programming phase.
For this reason, using a second 3 unstable position toggle switch
(+/- toggle switch) it is possible to change reduced speed levels in
real time for each joystick, in order to adapt the application's response to load and precision needs
that are required at the moment.
With the DSC, reduced speed limits may vary within the minimum and maximum limits set in "hare"
mode.
DSC+: increases the reduced speed limit as long as the joystick is at the end of its stroke.
DSC-: decreases the reduced speed limit. In this case joystick position is non influential.
Corrections carried out with the DSC remain valid until the receiver is turned off. The next time it is
turned back on the limits that were previously programmed with the limits calibration will be restored.
Turning only the transmitting unit off and on will not erase the corrections carried out with the DSC.
During the programming or test phase, for minimum and maximum limits of analogue outputs, the
DSC function is not active.
The DSC function is excluded by the activation of the "Snail-S" mode.
Anomaly Possible solution
It is not possible to have exclusive control
of the desired receivers.
Verify they are not already controlled by another TX: in
this case, carry out an Unlock procedure with the
transmitter controlling the desired receivers.
Verify that the correct combination using the rotating
selector has been chosen.
Verify the combinations in the attachments.
It is not possible to free the receivers with
the Unlock procedure.
A frequency change with the selected receivers has
been carried out: switch off all interested receivers.
It is not possible to put the receivers
selected previously with the Lock procedure
into gear.
A frequency change with the selected receivers has
been carried out: switch off all interested receivers and
carry out the lock procedure again
To Next Page
Loading...
