EasyManua.ls Logo

IMET M550 - iREaDy Option for Enhanced Safety

IMET M550
53 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IMET - M550 ALL1-EN 35/53
P9
P2
P4
P6
P1
P3
P5
T
E
S
E
R
S
E
R
T
E
R
E
S
E
T
P
O
T
S
T
S
O
P
P8P7
START DATA
LED IR
LB608
Power 12-24 Vac / 12-28 Vdc
Imax 40 mA
7.3. iREaDy Option
With this option it is possible to activate the radio remote control only if pointing the transmitter
towards a supplemental receiver unit called iREaDy receiver. Transition of the start signal takes place
through an infrared ray combined with the normal radio signal.
The additional safety makes it possible to avoid
involuntary and undesired start-up of the radio remote
control and therefore of the system
7.3.1. Warnings
Steps and behaviour to be adopted when using infrared:
Do not look at the LEDs directly or point them directly towards
someone's eyes.
Do not attempt to replace or repair the LEDs, since these
components cannot be replaced or repaired by the user.
Do not scratch the lenses.
Periodically clean the lenses with a clean soft cloth
7.3.2. Transmitter
The transmitter with the iREaDy option is equipped with two led for
infrared transmission. It is sufficient to point the transmitter
towards the iREaDy receiver and press the Start key. Maximum
transmission distance is:
30m with indirect solar light
20m with direct solar light
The transmitter with send the recognition code by way of radio and
infrared. The application will only activate if both codes are
recognised by their respective receivers.
7.3.3. Receiver
The iREaDy receiver must be installed close to the receiver of the radio remote control and connected
according to the diagram shown below.
The power supply must conform to the
requirements contained in paragraph
7.3.5. The following LED are present on
the iREaDy receiver:
LED for reception of the infrared signal
(IR LED).
Green DATA led: indicates reception
of the infrared signal: it lights up every
time the infrared reception LED
receives a signal.
White START LED: indicates that the
infrared signal is correct and the receiver
activates the relay connected in series
with the relay of the radio receiver
POWER
SUPPLY
RX
A
LIMENTAZIONE
iREaDy
relay
START
ralay
START
COMANDO
POWER
SUPPLY
A
LIMENTAZIONE

Table of Contents

Related product manuals