To Next Page

To Previous Page

NanoPhotometer

N120/NP80/N60/N50/C40 User Manual Version 4.3.1

Note: A new Blank is recommended when changing the dilution lid.

5. Select the Units in which the concentration should be calculated.

Options are ng/µl (default), µg/µl and µg/ml. pmol/µl if a nucleic acid sequence is entered

for nucleic acid factor calculation.

6. The background correction is enabled at 320 nm by default. Selection options are 320 nm,

340 nm or any wavelength in the range of 220 – 350 nm. The background correction can

be disabled with the toggle switch.

7. Air bubble recognition is disabled by default. Setting to on detects air

bubbles, lint residues and bad sample conditions of the sample.

Note: Lint residues and bad sample conditions are detected even if the

air bubble recognition is set to off.

8. For dye labelled samples tick the dye labels in the list, which should be used for result

calculation.

Note: If the used dye is not available in the list, please go to preferences and add a custom

dye to the dye list.

There is an option for dye correction which can be enabled/disabled with a toggle switch.

Note: Dye correction is only available for single dye selection.

Implen NanoPhotometer N120 User Manual

Questions and Answers: