15
- Check the F2 / switch function. To do so, steer with the joystick.
With the pressure rail extended, the cutter drive must move slowly until the joystick
stops moving.
- Release the manual brake. (there is no manual brake available at the option of
“automatic hose drum”)
- Unreel enough hose for cutter deployment in the ducting! To do so, either unreel hose
manually or – if the automatic unreeling unit is installed – steer the joystick “Driving” on
the control unit up and pull on the hose until enough hose has been unreeled!
- Turn off all switches on the control unit, the air shutoff valve on the drum and remove
the cutter drive from the auxiliary pipe!
To Next Page
Loading...