User Guide - v7 23
To change your PC’s settings, use the Windows Network Settings configuration application
to set the PC’s IP address and subnet mask.
1. Open Control Panel >Network and Sharing Center >Change adapter settings.
2. Right-click Local Area Connection and select Properties.
3. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties.
4. Set the IP address to an address close to the factory IP address, for example,
10.5.1.2, and change the PC’s subnet mask to 255.0.0.0 (the same as the
factory default).
5. Click OK, then OK again to save the changes.
Configure your device
All devices are supplied with their IP address and subnet mask set to 10.5.1.10 and 255.0.0.0
respectively. You cannot connect the device to your network until you have changed these
settings to suit your network.
After you have changed your PC’s network settings, you can change the IP values of the
device from its factory defaults.
1. Open the Internet Explorer application.
2. Enter the factory default IP address into the browser address bar, then click OK.
Default: 10.5.1.10
The Configuration Home page opens.
3. Click Network on the left of the page. The Network page opens.
4. Configure the settings to suit your installation.
The following fields are available:
• Use DHCP — Select to assign the following network parameters via a DHCP Server:
• IP Address
• Subnet Mask
• Default Gateway
• Host name
• Network Time Server Address (if enabled on the Date &Time page)
IndigoVision recommends that if you are using DHCP, you should configure the DHCP
server to assign a given IP address based on the device’s MAC address. Also, if the device
does not receive any response from the DHCP server it will default to using the network
parameters supplied by the last completed DHCP request.
If you are not using DHCP, you must enter the information manually.
• Host Name — Enter a name for the device to identify it. The name can only contain
alphanumerical characters and hyphens.
• Location — Enter a location to identify the device. The location can only contain
alphanumerical characters and hyphens.
• IP Address — Enter the IP address of the device.
• Subnet Mask — Enter the IP network subnet mask.
Enhanced SDFixed Dome - 9000 Range 3 Getting Started
To Next Page
Loading...