iNetVu
®
Mobile Installation Manual Page 37 of 93
Fig. 18: GPS antenna plate for the magnetic mounting
19. Apply caulking to prevent moisture from entering the opening.
Fig. 19: Completed roof wiring entry point
20. Install a standard 100A electrical service entry fitting (a clamshell fitting intended for
residential 115 / 230VAC electrical hook-up to a city supply is recommended) over the
cable entry point.
Ensure that the clamshell fitting is positioned so that the cable entry point faces the
rear of the vehicle. This will minimize the effects of wind driven rain.
To Next Page
Loading...