8-17 Maintenance
kina22e chapter 8.fm technical handbook(1206)
Notice: The Ecotec E3000 must be set to ADVANCED user mode for confirming
maintenance tasks. (Go to
SETTINGS / DISPLAY / USERMODE)
Notice: The ECO-Check reference leak must be installed in the Ecotec E3000
when pressing OK.
Notice: Entering the new leak relevant codes is important as otherwise an accurate
calibration with the internal test leak and traceability of the calibration
cannot be guaranteed.
Notice: The empty container is not reusable and should be disposed off according
to national law.
Fig. 8-20 Entry screen for replacing the ECO-Check
To Next Page
Loading...
