EonStor CS Installation Guide
page 68 / 165
4U 60-bay form factor model
1. Please shut down the faulty node before replacing it. Disconnect all cables on the faulty controller and
remove it, insert the new one and power on the GS.
2. To remove the faulty controller, you need to unfasten the retention screw, hold the rim, and pull the
controller out of the enclosure.
3. Insert the replacement carefully until you feel the contact resistance when the board edge connectors
are engaging the backplane.
4. Secure the replacement controller to the enclosure with the retention screw. Kindly note that the new
controller would be set as factory default before shipping.
To Next Page
Loading...
