InfraTec VarioCAM - Advice on Device Safety; General Safety Advice; Standards and Guidelines

User Manual for the Thermographic System VarioCAM
®
high resolution
2. Advice on Device Safety
User Manual © InfraTec GmbH 2013 3
2 Advice on Device Safety
General
The VarioCAM
®
hr is a high-quality, thoroughly calibrated optical measuring instrument. Handle it with
appropriate care. Avoid soiling it, particularly its optical surfaces.
The device has protection class IP 54.
Please observe the conditions specified under Technical Data (see Chapter 3.3, Technical Data, page 9)
for use, save and transport of the device.
For transporting the VarioCAM
®
hr, exclusively use the transportation case included.
Opening the camera case is reserved for customer service or authorised staff only. Any interference by
the user or unauthorised persons is not permitted and will void any warranty.
Only use accessories or spare parts which are expressly recommended by JENOPTIK Laser, Optik,
Systeme GmbH for use with the VarioCAM
®
hr. Otherwise malfunctions or damage can occur. Warranty
shall be excluded for such damage.
Standards, Guidelines
The VarioCAM
®
hr complies with the requirements of the following standards:
■ EN 61010-1:2001 Safety requirements for electrical equipment for measurement, control and
laboratory use – Part1: General requirements (IEC 61010-1:2011)
■ EN 61326-1:2006 Electrical equipment for measurement, control and laboratory use – EMC
Requirements – Part1: General requirements (IEC 61326-1:2005)