User Guide Payment terminals | 9
1.5 Installing iWL250G/B
iWL250G = Uses GPRS communication
iWL250B = Uses Bluetooth communication to the base station. The base station is connected to broadband.
To install and charge an iWL250, do as follows:
Connect the power cable to the base station.
Place the terminal on the base station.
The terminal will connect and is then ready for use.
The new terminal comes with a battery that has been minimally charged.
The terminal must be charged to perform to the full.
Connecting the base station to network
When using the restaurant solution Pay@Table or a wireless router, an Ethernet cable must be connected from the
ECR or router to the base station. The base station communicates with the terminal via Bluetooth.
Connect the Ethernet cable (1) and power cable (2) as
shown in the image. Place the terminal on the base station; the terminal
will connect and is then ready for use.
Continued on next page
!
To Next Page
Loading...
