InHand VG710 - Page 49

InHand VG710 InVehicle Gateway User Manual
44
5.6.2.3 BGP
Method for enabling dynamic routing between VG710_A and VG710_B over BGP in the
scenario:
1. Configure VG710_A. Click "Routing >> Dynamic Routing >> BGP", check "Enable", and set "AS
number" as required.
2. In the "Neighbor" bar, click Add, enter the IP address 192.168.1.2 of VG710_B, set "AS number"
as required, and click Apply & Save.
3. Enter a valid IP address for "Router ID", configure VG710_A in the "Network" bar, and click Add,
to announce the routing entry of VG710_A. Then click Apply & Save.
4. Set parameters for VG710_B. The parameters are the same as or corresponding to those of
VG710_A.