InHand VG710 - Track

InHand VG710 InVehicle Gateway User Manual
46
5.7.2 Track
Currently, linkage is enabled between the track module and the following application modules: VRRP,
static routing, and interface backup. If detection succeeds, the corresponding track entry is in the
Positive state. If detection fails, the corresponding track entry is in the Negative state.
Method for adding a track entry for VG710:
Click "Link Backup >> Track >> Track", set "Index" as required, select "sla", "interface", or "vrrp" for
"Type", set "SLA/VRRP ID" based on the ID in the SLA list, set "Negative Delay (s)" and "Positive
Delay (s)" as required, click Add, and then click Apply & Save.
Negative Delay (s): In case of an abnormal state, switching can be delayed based on the delay setting
(0 indicates immediate switching).
Positive Delay (s): When a failure is recovered, switching can be delayed based on the delay setting (0
indicates immediate switching).
Method for adding an IPsec track entry for VG710: